NETW 410 WEEK 6 LAB REPORT

BUY HERE⬊

http://www.seetutorials.com/devry/netw-410/netw-410-week-6-lab-report/

NETW 410 Week 6 Lab Report

Lab 6: Routing Protocol Selection

1. Complete this table on routing protocols. However, many rows are needed for the routing protocol names. (10 points)

2. Should the individual buildings be connected to the Administration Building at Layer 2 or Layer 3? (10 points)

3. If the individual buildings should be connected to the Administration Building at Layer 3, which routing protocol or protocols should be used? (10 points)

4. Apply the concept of Cisco Enterprise Architecture to the new network design. Which of the six major functional areas apply to this network? Draw a diagram similar to the figure in the textbook in Chapter 3 that illustrates the use of the Cisco Enterprise Architecture for this network. (10 points)

5. Using the diagram created in question 4; indicate which of the routing protocols could be used at each interconnection point between the functional areas. (10 points)

6. Considering your answer to question 3, will route redistribution be required? If it will, using the diagram created in question 4, indicate where the router redistribution will need to occur. (10 points)

7. Could STP be used instead of a routing protocol in this campus network? What would be the implications of doing so? (10 points)